Communications

• CAN for transmitting and receiving FIA specified data
• RS232 for receiving GPS data
• USB for communication with ADR2 Manager

Connectors

• 1 x 13 pin Autosport connector size 10

Physical construction and dimensions

• Case size: 86 mm x 45 mm x 25 mm
• Case material: anodized aluminium
• Ingress protection rating: IP66 / IP67
• Operating temperature: -40 to 85 °C
• Weight: 130 g

Power

• Power supply: 6 – 32 V
• Current: nominal 200 mA @ 12 V (with external GPS), maximum 1 A when charging backup power supply
• USB power when connected to PC (when no other power source connected)
• Backup power supply
  • provides power for at least 45 seconds of continued recording after vehicle power is lost
  • recharges in less than one minute after vehicle power is applied

Medical and status light outputs

• Topology: current limited open collector high-side drive

• External load: LED to GND or logic level input with pull-down resistor

• Voltage on: 5 V - Regulated

• Voltage off: 0.3 V (with external 10k load to ground)

• Voltage off: 2 V (approximately, when not connected)

• Current Limit: 20 mA

• Reverse polarity protected

• Voltage diagnostic feedback

Operational

• Recording of lateral, longitudinal and vertical accelerations at 3000 Hz
• Recording of CFC60 filtered acceleration data at 1000 Hz
• Acceleration channel resolution: 0.125G
• Recording of FIA specified CAN channels
• GPS data recorded:
  • Date and Time
  • Latitude and Longitude
• Accelerometers range: -480G to +480G
• Accelerometers overload: 1800G minimum
• Pre-accident recording: 15 seconds
• Total event recording: minimum 30 seconds, extended on subsequent impacts
• Data output format: CSV

Connector: 13 pin Autosport size 10 (AS 2 10-35 PN)

Mating connector: AS 6 10-35 SN

RGB LED Indicator

* When an event is recorded, the LED shows Event stored until the device is powered down. If the device is powered on and a recorded event has not been retrieved by ADR2 Manager, the LED will show Event stored for 60 seconds.

** Duty cycle equals charge level; i.e. 20% duty cycle = 20% charge level.

*** Flashing to indicate command in progress e.g. firmware update. All normal operations are suspended.

Diagnostics

When an error occurs, the RGB LED indicator will flash orange ON for 250 ms at 50% brightness, OFF for 250 ms, repeated according to the error number (see table), followed by a one second pause.

Only the highest priority error (lowest number) is displayed and this continues for as long as the error is active.

Additional information on errors or internal faults can be found in the diagnostic channels section in ADR2 Manager software.

External Status Light

* When an event is recorded the status light will flash until the device is powered down. If the device is powered on and a recorded event has not been retrieved by ADR2 Manager the status light will flash for 60 seconds.

External Medical Light

• Directive 2014/30/EU: Electromagnetic Compatibility; by application of UNECE Regulation No.10 (R10) Rev 6 20/11/2019.