Inputs

• 23 x switch inputs: range 0 to 51 V, resolution 0.2 V

Outputs

• 8 x 20 A outputs: 20 A continuous, 115 A transient (typical)
• 24 x 8 A outputs: 8 A continuous, 60 A transient (typical)

Communications

• 1 x CAN

Operating Voltage

• 30 V max

Ingress Protection (IP) Rating

• Rubber seal on lid and connectors, conformal coating on PCB
• The device is rated to IP67

IP rating is dependant upon the user ensuring that the connector entries are waterproof, which, as a minimum, requires all unused wire cavities on the connector to be plugged.

Physical

• 1 x 37, 1 x 26, 1 x 8 and 1 x 1 pin Autosport connectors
• Case size 180 x 60 x 28 mm
• Weight 420 grams

MoTeC ECU Models

• M1 Series (package dependent)
• Discontinued: M84, M400, M600, M800, M880

MoTeC Dash/Logger Models

• C125, C127, C1212, C185, C187, C1812, CDL3, L120, L180
• Discontinued: SDL, SDL3, ADL, ADL2, ADL3, ACL

CAN Wiring

To communicate to the PC, a CAN connector must be wired into the CAN bus. To connect the PDM directly to the CAN connector, wire according to the following table.

Example Wiring

Wire Gauges

Suitable wire gauges are 24# to 20# for the 8 A outputs and 20# to 16# for the 20 A outputs. The wire gauge must be chosen to suit the current consumed by the connected device and to ensure that the voltage drop is acceptable. In a long run it may be necessary to use a heavier gauge wire to minimise voltage drop. The wire gauge must also be compatible with the connector pin; using a smaller than recommended wire gauge may result in a poor crimp.

Connector A

37 pin Autosport connector

Mating connector #68089

Connector B

26 pin Autosport connector

Mating connector #65040

Connector C

1 pin waterproof connector

Mating connector:

#68093 (wire gauge #6 AWG)

#68094 (wire gauge #4 AWG)

Connector D

8 pin waterproof connector

Mating connector: #68092 (Deutsch AS616-08SN)

IP Rating (dust or water ingress)

Operating Temperature Range

This product is designed for an internal operating temperature range of -40 °C to 85 °C.

It should be installed in a location with sufficient air circulation and be shielded against thermal emissions from surrounding components.

Vibration Statement

This product is designed to withstand vibrations typical for normal vehicle installations.

It should not be exposed to severe and lasting vibrations. For example, the product should not be installed in solid connection to vibrating components like engines or undamped vehicle structures.